DFRobot Gravity Analog EMG Sensor by OYMotion

$50.00


This EMG sensor is launched by the cooperation of DFRobot and OYMotion, which can detect sEMG to reflect muscle and neural activities of human.

This sensor integrates filtering circuit and amplified circuit. It amplifies minimal sEMG within ±1.5mV 1000 times and depresses noises (especially power frequency interference) by differential input and analog filter circuit. The output signal is analog,which takes 1.5V as the reference voltage. The output voltage range is 0~3.0V. The signal strength depends on the intensity of muscle activities. The output signal waveform indicates the muscle activity and contributes to analyze and research the sEMG. Specifically, we can use Arduino as a controller to detect muscle activities, e.g. check whether the muscle is tense; the muscle strength, etc.

This is an active induction sensor can provide high quality signal collection and it is easy to use. Only simple preparations are needed to apply the module for either static or dynamic areas. Dry electrode is applied to the module and good quality signal are available even without conductive gel. Compared with disposable conductive gel needed by medical electrodes, it is more convenient to use and extend its long-life service. Therefore, it is more suitable for most of users.

Measurements with an analog EMG sensor are noninvasive, convenient and this can be applied in human-computer interactions. With the development of microcontrollers and integrated electric circuits, EMG circuits and sensors have not been applied to traditional medical muscle detection researches but control systems.


FEATURES

Metal Dry Electrode: long life, easy to use

Differential input, high common mode rejection ratio

Low power consumption

Single power supply

SPECIFICATION

Signal Transmitter Board

Supply Voltage: +3.3V~5.5V

Operating Voltage: +3.0V

Detection Range: +/-1.5mV

Electrode Connector: PJ-342

Module Connector: PH2.0-3P

Output Voltage: 0~3.0V

Operating Temperature: 0~50℃

Size: 22mm*35mm (0.87inch*1.38inch)


Dry Electrode Board

Electrode Connector: PJ-342

Wire Length: 50cm(19.69inch)

Plate Size: 22 * 35 mm (0.87*1.38inches)

weight: 36g

Write a review

Please login or register to review